Industrial Square Type Commercial Water Closed Circuit Cooling
1. Advantage of closed circuit cooling tower:
Cooling medium is fully closed circulation in case that the debris
into cooling system and to prevent the loss of cooling medium.
Soft water is not easy to scale, not blocking the pipeline.
Using cold water and spray water evaporation endothermic double
cooling method with a high cooling efficiency.
The device has the advantages of small size, convenient movement
Using of automatic intelligent control, according to the
requirements of the operating conditions automatically change the
Widely used, can directly cool the quenching liquid, oils, alcohols
and other media that do not corrode the heat exchanger (copper
tube), no loss of media, stable composition.
2. Brief Introduction of closed circuit cooling tower:
The primary use of cooling towers is to remove the heat absorbed in
the circulating cooling water system used in power plants,
petroleum refineries, petrochemical plants, natural gas processing
plants, food processing plants, semi-conductor plants Etc… So Same
Cooled Water Can Be Used Again… Which Saves Precious water …The
smallest cooling towers are designed to handle water streams of
only a few Liters of water per minute supplied in small pipes like
those might see in a residence, while the largest cool hundreds of
thousands of Liters per minute supplied in pipes as much as 15 feet
(about 5 meters) in diameter on a large power plant.
A Cooling Tower is a heat exchange system that removes waste heat
from a process system fluid, usually water.Cooling towers are used
in both commercial and industrial applications.
Technical Parameters of Water Cooling Tower
Water Cooling Capacity
60000kcal / h
Cooling Water Flow
380V - 50HZ
Water Outlet Diameter
Water Inlet Diameter
Water Replenishing Diameter
Drain Outlet Diameter
Fan (power of the generator)
3. Parts of Closed Type Cooling Tower:
- Coil: Made of high-quality seamless steel pipes. The coil unit are
galvanized entirely to improve the corrosion resistance ability and
extend the service time. The coils can also be made by SS-304/316L
stainless steel or T2 red copper. Maximum pressure of our coils
could reach to 32Mpa.
- Spray Pump: Sealed by top quality rotary no-limited machinery seal, no
leaking, long lifecycle, small horse power, large flow volume, low
noise and high performance.
- Fan: Aluminum alloy axis-flow type
- Casing: SS-304/316L or imported Aluminum-zinc alloy plate.
- Removable Drift Eliminator: PVC material; Make sure that the water loss rate will be less than
- Cooling Tower Fill: 100% Original Material PVC Infill, special design with great
4. Cooling Tower Package:
1. the body is designed to 2 parts: upper body and bottom body, can
be easily divided into two parts, and loaded into container;
2. shipping with 20ft and 40ft container.
|Large Melting Furnce|